Forum  NWKite Forum Hammersurf Ono 147cm (4'10") $150 OBO
|
|
Hammersurf Ono 147cm (4'10") $150 OBO |
Author: Onad Rednaxela
Posted: Wed May 02, 2007 7:03 pm (GMT -8)
Selling the 147cm (4'10") Hammersurf Ono for $150 OBO. The board, pads and foot straps are in good shape. A couple of the fins have started to strip out so they need to be replaced.
The ONO is a super fast, stable board. Goes upwind effortlessly, edges hard and boosts big. The board is great in the surf, for which it was designed. The riders stance can be adjusted to ride more powered in a directional type of ride or move the bindings in the middle of the board for a twin-tip stance. It can be ridden like a twin, but the stance on deck is offset 1.5†toward the tail for “directional†surf-style riding when desired. The fin configuration compliments this.
4’ 10†ONO surf style model:
-Two (2) 1.75†epoxy fins.
-Two (2) 2.5†epoxy tail fins.
-Two (2) top-secret .7†rail fins.
-Six (6) stainless ¼-20 x 1-1/4†flathead machine screws for fins.
-Six (6) anodized aluminum washers for flathead fin screws.
-Four (4) stainless 10-24 x 1-1/8†flathead machine screws for rail fins.
-Four (4) anodized aluminum washers for flathead rail fin screws.
-One pair Dakine Vario Footbeds.
-One pair Dakine Vario Footstraps.
-Four (4) rectangular footstrap washers with stainless backing plate.
-Four (4) stainless ¼-20 x 3/4†panhead machine screws for footstraps.
4’ 10†ONO set up:
-Position 1.75†fins as tail fins at the front of the board.
-Position 2.5†tail fins at tail, with a single machine screw and the set posts in the fins.
-Position .7†rail fins with shallow entry forward.
-Fasten in place with supplied hardware. No need to over tighten, just snug the screws up every 2-3 sessions.
|
|
